LED Safety Line Projector Series

Industrial LED line projection series for walkways, traffic lanes, staging areas and exclusion-zone demarcation without floor-contact marking.

Power Output 100–200W configurable reference range

Input Voltage 9-80V

Typical Height 3-5M

Protection IP65 Rated

Application Engineering Note

Projection visibility is determined by mounting height, ambient lux, lens optic selection, and floor reflectivity. SNT provides exact Gobo pattern sizing and optical validation prior to pilot deployment.

Detailed Description & Functional Overview

Lens Model / Ratio	Recommended Distance	Projected Pattern Size	Application Suitability & Notes
Standard Line Optic	3–7 m	Line length and width project-specific	For aisle, walkway and staging line applications.
Wide Line Optic	4–8 m	Wider coverage; project-specific	For larger demarcation areas.
Long-Throw Line Optic	6–10 m	Project-specific	For higher mounting; final line width must be validated.

Industrial LED line projection series for walkways, traffic lanes, staging areas and exclusion-zone demarcation without floor-contact marking.

Typical Applications

This product series is intended for industrial visual safety projects where configuration must be matched to actual site conditions.

Reference Configuration

Light / Signal Source: High-power LED with line-forming optic
Power / Output: 100–200W configurable reference range
Input Voltage: AC 100–240V, 50/60Hz (verify final model)
Recommended Installation Height: 3–10 m typical application range
Environmental Protection: IP65 target/reference; verify final model
Control: Always-on / flashing controller / sensor / PLC trigger

Lens / Optical Configuration

Standard Line Optic: 3–7 m — Line length and width project-specific. For aisle, walkway and staging line applications.
Wide Line Optic: 4–8 m — Wider coverage; project-specific. For larger demarcation areas.
Long-Throw Line Optic: 6–10 m — Project-specific. For higher mounting; final line width must be validated.

Selection Information Required

Please provide the application, mounting height, projection/detection distance, ambient light, required marking or detection area, floor/environment conditions, trigger logic and project quantity before final configuration. Draft website data: reference specifications must be verified against the final SNT datasheet before publication or quotation.

Configure this system for your facility.

SNT recommends projection models based on your exact ceiling height, ambient lux, floor surface, and safety message requirement. Submit your data for an application review.

Pilot Validation Process

01. Parameter evaluation & optical simulation
02. Tailored pilot unit shipment with chosen gobo
03. On-site visibility test & pilot pass decision
04. Standardized bulk deployment & replication

BUYER SUPPORT

Not Sure Which System Fits?

APPLICATION SUPPORT

Solve Specific Site Risks

BUYER SUPPORT

Not Sure Which System Fits?

FEATURED RESOURCE

How Crane Warning Lights Create Visible Hazard Zones Below Overhead Loads

LED Safety Line Projector Series

Technical Specifications & Optical Sizing

Standard Parameters Verified Values

Environmental & Compliance Industrial Grade

Optical & Gobo

Mounting Hardware

Trigger & PLC Control

OEM / Private Label